Sheet Metal
For all vehicles
Choose a subcategory to continue
The parts you want are deeper in this branch.
Subcategories
Full complete floor pans - must have truck freight and crating fees do apply
9 parts match
These Reproduction Floor Pans have all the correct drain holes and design as the originals. Each section covers just the flat square floor sections and aprox. 2" of the upward sides of the floorpan on all four sides of each pan. All floor pans are a 20 gauge metal with a natural finish.
58 parts match
All E-body Fenders are the 14” style – not the 15” for the high performance 6-pack, Hemi and AAR / TA cars that has special 15” fenders to clear for the 15” tires.
26 parts match
Many times missing and almost always rusted and in need of repair. Attaches to the LH front frame rail on cars equipped with automatic transmissions. Our starter splash shield is a faithful reproduction of the original part. Made from heavy gauge sheet metal on new tooling. Each piece features correct as original rubber seal
1 parts match
These reproduction quarter panels skins are electonically coated with an anti-rust primer. While there may be hand-formed panels available for less, we feel that our die-stamped reproductions are superior in every way. These quarters are not intended to be replacement factory quarter panels, but when professionally installed, they are an excellent method of major rust and damage repair. Unless otherwise note, these are for 2 dr vehicles. Due to the size of these products, they are shipped by truck.
** All Quarter Panels must be shipped Truck Freight. Additional Shipping Charges Will Apply.
SEE SHIPPING FOR DETAILS
We have found the average shipping cost via Yellow Freight is aprox. $125 per panel. Of course this is based on zip code location and if any Fuel Surcharges are in effect from the shipping companies at the time...
99 parts match
Inner and Outer rocker panels. The inner rocker is referred to as the "structural" piece whereas the outside skin is the visible painted finish piece.
24 parts match
These steel trunk lids include correct underlid bracing and welded cage nuts for mounting to hinges. All trunk
lids come with a black primer finish and are ready to paint and install. Truck Freight!!!!!
8 parts match
Quality die-stamped reproductions will correctly replace your unusable original. All of our trunk pans are manufactured from high-quality automotive-grade steel, and feature the correct contours for the proper appearance. Be sure to order our trunk extension panels to properly repair the rust in those areas as well. NOTE: The original trunk floors were one piece, but they were installed before the quarter panels were hung. With the exception of our full trunk floors listed, our trunk floor panels are manufactured in two pieces (LH and RH) with offset welding steps overlapping in the center. This allows easier installation. Our reproduction trunk floor panels do not require body drain plugs since no holes are punched in the floor pans. If originality is important to your restorations, simply cut out the body drain plugs and use our reproduction rubber and plastic plugs found in this section. Tabs/brackets for jack/spare tire mounting not included.
17 parts match