Trunk Floor Component Parts
For all vehicles
Choose a subcategory to continue
The parts you want are deeper in this branch.
Subcategories
Natural color for use as a water and dust seal on interior and exterior body surfaces. Can be air dried or baked after application. Use on drip molds, trunk welds, body welds and body seams. Will not harden or become brittle. Sealer surface must be painted.
0 parts match
Quality die-stamped reproductions will correctly replace your unusable original. All of our trunk pans are manufactured from high-quality automotive-grade steel, and feature the correct contours for the proper appearance. Be sure to order our trunk extension panels to properly repair the rust in those areas as well. NOTE: The original trunk floors were one piece, but they were installed before the quarter panels were hung. With the exception of our full trunk floors listed below, our trunk floor panels are manufactured in two pieces (LH and RH) with offset welding steps overlapping in the center. This allows easier installation. Our reproduction trunk floor panels do not require body drain plugs since no holes are punched in the floor pans. If originality is important to your restorations, simply cut out the body drain plugs and use our reproduction rubber and plastic plugs found in this section. Tabs/brackets for jack/spare tire mounting not included
18 parts match
These extension panels travel from the outer sides of the trunk floor down to the bottom of the quarter panelS where the drain plugs are located. These reproductions are constructed of die-stamped automotive grade 20-gauge steel. Note: Some reproduction trunk extension panels do not require drain plugs since no holes are punched in the panels. If originality is important to your restoration, simply cut out the drain holes and use our reproduction plastic plugs (See Body Plugs within the "Body Section" of the catalog).
33 parts match