Fuel

These Reproduction Fuel Tanks are high quality Ni-Tern LT35 steel and are leak tested twice underwater to assure flawless performance. Each Tank is assembled on a low-scratch assembly line, wrapped in plastic foam, shrink-wrapped and then boxed in heavy-gauge corrugated cardboard so they arrive in great shape. PLEASE KNOW – THESE ARE NOT THE CHEAP CHINESE JUNK ALSO ON THE MARKET FOR HALF THE PRICE…OTHER RETAILERS ARE SELLING THEM AND THEY ARE NOT THE SAME QUALITY - FIT ISSUES, MADE OF CHEAP STEEL THAT WILL RUST INSIDE AND OUTSIDE UNLIKE THE Ni-Tern LT35 TANKS THAT WE SELL THAT WILL NOT RUST – PERIOD! THERE IS A BIG DIFFERENCE…WE CAN SUPPLY THE CHEAPER CHINA PIECES IF YOU ARE REALLY GUN HO ABOUT GETTING ONE, BUT WE WILL NOT WARRANTY THEM… Due to the size of these tanks, they are shipped UPS oversize. Note: E.C.S. Models have a vapor separator in the trunk compartment and four vapor tubes exciting the tank. Look for E

We carry new reproduction fuel sending units for A,B,C,E-body models. If you do not see a new reproduction listed below for your vehicle, check out or N.O.S. sending units under our N.O.S. parts listing. We make 'em in 5/16" fuel line and 3/8" fuel line for every application (and 1/2" for some). That way if you want to use the stock fuel system, but have taken out that Slant-6 engine and replaced with a 440, you can fuel the beast with our 3/8" fuel sending unit that is stock to that vehicle (except for the larger line). Add our O.E.M. or Stainless 3/8" fuel lines for the rest of the car and you won't have any problems getting fuel. NOTE Our reproduction units come with a fuel sending unit-to-tank seal and the pick-up tube filter sock. Finally - These NEW units are going to be off a bit when "FULL" as current production in Taipai is using different OHM settings causing the reading to be low. We hope to have this problem solved in the future.

We have new reproduction fuel filler tube caps, or gas caps. Forget one on a pump... or just have a car that the previous owner converted to a locking cap and now lost the key to it? Get back to stock!! We have reproduced these to exact specifications with a little improvement. We also have the aftermarket cap that was sold for quite a while until several years ago. We have brought them back since many of you out there expressed you preferred this cap over the originals. This cap is fully chromed, even the straight handle has been chromed sepearately and then attached for a clean look.

Fuel pumps play a vital role in the operation of your classic muscle car. These are the same fuel pumps originally used by Chrysler Corporation, and are manufactured by Carter or Chrysler.

Throttle cables attach the gas pedal to the carburetor linkage which in turn opens up the throttle plates. After years of use, these cables can stretch, break, or stick -- rendering them useless. When it comes time, replace them with these New Chrysler cables.