Here we have the "plugs" that are correct replacements for those rocker panel and side mldg clips that require the "bullet" type plug that goes into the middle of the clip. This "plug" is pushed into the round hole of the clip when placed on the car to hold it in place.

Part# PM-CLIP679

Rocker Molding clip Kit. For B-Body these are for the Dodge Rocker mldgs only. Please Note: This clip may not fit for original moldings for a 1969 Barracuda. Also, to apply on Dodge Darts with new molding # PM-CMR6769A (not original rocker moldings but the reproductions ones) one has to obtain 1/4 inch stainless steel washers and drill out the washers with 5/16" bit and mount behind each clip to allow the clip to be pushed away far enough from the vehicle to then mount the rocker mldg to the vehicle. Without the washer, the rocker mldg will touch the paint BEFORE the clip "snaps" into place on the backside of the rocker molding (20 piece kit)

Compatibility: 1968 - 1969 A-Body Availability: 3 in stock

Your Vehicle:

Part# PM-CLIP679