Quality die-stamped reproductions will correctly replace your unusable original. All of our trunk pans are manufactured from high-quality automotive-grade steel, and feature the correct contours for the proper appearance. Be sure to order our trunk extension panels to properly repair the rust in those areas as well. NOTE: The original trunk floors were one piece, but they were installed before the quarter panels were hung. With the exception of our full trunk floors listed, our trunk floor panels are manufactured in two pieces (LH and RH) with offset welding steps overlapping in the center. This allows easier installation. Our reproduction trunk floor panels do not require body drain plugs since no holes are punched in the floor pans. If originality is important to your restorations, simply cut out the body drain plugs and use our reproduction rubber and plastic plugs found in this section. Tabs/brackets for jack/spare tire mounting not included.

Part# IN-M216

1-piece trunk floor. Measures 31" front-to-rear and spans the entire distance between the trunk extension panels (approximately 51"). SHIPPING INFORMATION: Crating will measure 54" x 33" x 8" and weigh 35 pounds.

Compatibility: 1967 - 1976 A-Body Availability: Special order

Your Vehicle:

Part# IN-M216