Wiring Harnesses

Engine Foward light harnesses travel to the battery junction, the headlights, parking lights and turn signals. Other connections may vary depending on your particular model. All foward lights harnesses are covered using the factory-style non-adhesive vinyl wrap tape (See our part #SR-190340) and feature the correct T-style positioning clip. The foward light harnesses attach to the firewall via a 1-piece 8-way connector.

Most engine harnesses include several, if not all of the following connectors: temperature sending unit, oil light, coil power, horn relay, washer pump motor. Other connections mat vary depending on your particular modle. All of our engine harnesses are covered using the factory-style non-advertising vinyl wrap tape. (see our part#SR-190340)

This is the Forward light harness only. Does NOT include the harness for the Engine.

These are base dash harnesses only, Chrysler often added separate wire assemblies (each with its own set of connectors and terminals) under separate part numbers, according to a vehicle's final assembly configuration. Since many of these assemblies are not currently available, you will have to remove the original assemblies from the old harness side-by-side with the new one. We recommend laying the old harness side-by-side with the new one in order to isolate the additional wire assemblies. These new dash harnesses include the connectors and leads to various switches and electrical components, but not the switches and components themselves. All dash harnesses are covered using the factory-style non-adhesive vinyl wrap tape.(See our part #SR-190340 ) . Harness includes wiring for headlight, wiper/washer, flasher, turn signal, horn and ignition switches, panel (gauges/lights and heater), fuse box, bulkhead disconnect, and cigarette lighter connector (1-way is “NOT” included with th

Rear light harnesses travel from the dash harness or intermediate harness (which runs runs from the dash harness under the carpet or mat, and connects with the rear light harness in the back seat area.) They then connect to the rear tail light, back up lights, side markers, and turn signal lights. Other connections may vary depending on your particular model. All rear light harness listed fit two and four-dorr cars unless otherwise specified. None of these harnesses will fit station wagon models. All of our rear light harnesses are covered in either the factory-style paper braid or factory-style cloth tape.

Back up light harnesses run from the bulkhead connectot to the transmission back up switch. Other connections may vary depending on your particular model. These harnesses do not fit any Hemi models; all Hemi back up light harnesses are incorporated into the positive battery cables. All of our back up ligh tharnesses are covered using the factory-style non-adhesive vinyl wrap tape. (See our part #SR-190340)

Interior seat and other optional wiring harness

This is the correct non-adhesive wiring harness tape made by the OEM company for Mopar. This roll is 1-1/4" x 100ft. Black, fits all cars and trucks.