Taillight Bezel Components

These are the white foam gaskets that underlay to the black rubber main housing gasket.

This is the small black rubber gasket the fits between the tailight chrome mldg and the metal tailight bucket that fits into the quarter panel. Basically the sequence goes - tailight mldg, tailight mld gasket (these parts listed below), tailight lens, tailight lens gasket, tailight bucket or housing and finally the tailight bucket (housing) gasket (See below section) - then all that when assembled fits onto the car

These are the black rubber gaskets that fit between the chrome tailight bezel and the body of the car. There is a white foam seal that also applies to the tailight bezels and can be found in a separate section above called "Rear Tailight housing to body gaskets".

To Add the finishing touch to the inside of the trunk area, use these plastic original red stud protectors to cover up the studs sticking into the trunk bay. Use them to aviod the stud from "catching" on anything in the trunk and for the cosmetic final touch to the taillight housing. Can be used for other studs as well.

Found on the interior of the trunk are - these protective covers also add a good finishing touch to the trunk compartment.